Paul Agnew Aerion Series, Installation, Operating And Maintenance Manual, Page: 71 / 104

66.
INSTALLER INFORMATION
Aerion Range
REMOVAL OF OUTER GLASS PANELS
Step 1: With the glass in the horizontalWearing the gloves provided apply the glass suction pad (provided) to the centre of
the glass and engage.
Step 2: Removing outer side trim. Grip the trim
and apply an upward motion to disengage the
securing tabs from the slots in the inner trim.
When the tabs are clear of the slots, remove the
outer trim both sides (GF and GF3 model) For the
GF2L model remove outer trim from the Left-Hand
side.
Step 3: With one hand holding the glass pad,
with an upward motion lift the top of the glass
until engaging with the top of the inner fascia. The
bottom of the glass is now clear of the bottom
supporting channel. Swing the bottom of the glass
outward with one hand holding the glass pad and
the other hand gripping the bottom centre edge of
the glass.
Step 4: Lay the glass down on a protected surface and retain with the outer trims. lower front. Note do not discard the
outer trims with the packaging..
Step 5: For models with the side glass. With the
outer front glass panel and trims removed.
With one hand holding the glass pad, with an
upward motion lift the top of the glass until
engaging with the top of the inner fascia. The
bottom of the glass is now clear of the bottom
supporting channel. Swing the bottom of the glass
outward with one hand holding the glass pad and
the other hand gripping the bottom centre edge of
the glass. Remove the glass panel and retain in a
safe place.