Paul Agnew Aerion Series, Installation, Operating And Maintenance Manual

Page: 96 / 104

SERVICING
91.
DO NOT MODIFY THIS APPLIANCE
Service only to be carried out by an authorized person.
Turn the appliance OFF and isolate the gas supply. Ensure the appliance is fully cold before attempting to
start servicing the appliance. No liability can be accepted by Living Fire for injury caused by burning or
scolding by a hot appliance.
A suggested procedure for servicing is listed below.
1. Lay out dust sheet on flooring, mask off any special fireplace materials.
2. Remove Outer Glazing Panel
3. Remove Bottom Window Trim
4. Remove Inner Window Panel
5. Carefully remove the Ceramic components (including Embers) or Gravels
6. Use a Vacuum cleaner to clean the top of the burners and grate
7. Remove Grate
8. Using a vacuum cleaner, fully clean both Burner Top.
9. Use the vacuum cleaner and a soft brush to clean the pilot assembly and Injectors. Never modify or
bend the Thermocouple
10. Turn on the gas supply and check for leaks, check the burners and Pilot for good condition and
operation
11. Replace Grate
12. Replace the Fire bed arrangements
13. Replace Window Assemblies and Trims
14. Check the flue system and terminal, making sure that the terminal vent is fully clear
15. Light the appliance and test setting pressures
16. Check the safe operation of the appliance.
Aerion Range