36 | P a g e
PATON
®
ADI 200 PAC AC/DC TIG/MMA
CAN BE EXPLOSED:
Use only approved cylinders and properly functioning
reducers. The cylinder should be transported and positioned vertically. Protect
the cylinder from heat, overturning and mechanical damage.
WELDED MATERIALS CAN BE BUILDED: Under
no circumstances
should you touch welded parts with your bare hand. Always wear protective
gloves when operating the device. The arc and splinters that occur during the
current can cause skin burns. Use protective gloves and pliers when touching
or moving the workpiece.
ELECTRICALLY SUBSTANCED SOURCE:
It is forbidden to work with
damaged welding lines or on wet ground. Welding cables should be strong,
undamaged and insulated. Weak joints and damaged cables must be replaced
immediately. Do not move the unit by pulling the power cord or welding
cables. Do not carry out any maintenance on the unit if it is lost.
It is forbidden to remove the external housing of the device while it is
connected to the network, as well as to use the device with the cover
removed.
WELDING NOISE CAN BE DAMAGED:
The resulting welding arc during
welding may emit more than 85dB for - 8 hours of working time. Welders
operating the equipment are required to wear the equivalent of hearing
protectors during their working hours in accordance with the Regulation of the
Minister of Labour and Social Policy of 6 June
2014. - Journal of Laws of 6
June 2014. According to the Regulation of
the Minister of Health on Social
Welfare of 09.07.1996. Journal of Laws No. 68 item 194 - the employer is
obliged to perform tests and measurements of factors harmful to health.
CE CONFORMITY:
This device meets the recommendation of the European
CE Committee.
SAFETY SIGNAL:
This device is designed for mains supply, for welding
work in an environment with a higher standard of electric shock. It is
recommended that the power line be equipped with a separate protection
against electric shock.
Summary of Contents for ADI 200 PAC
Page 1: ......
