PVIQ™ CONNECTIVITY SYSTEM USER MANUAL V 1.0
149
Figure 114: Network Page (FW Update)
CLI Method
By default, no users may access the PViQ™ Connectivity System through Telnet. Each
user needing Telnet access to the PViQ™ Connectivity System must be granted that
access through the PViQ™ Connectivity Web UI. Refer to Section 2 - PViQ™
Connectivity Web User Interface (Web UI), on how to grant a user Telnet access to the
PViQ™ Connectivity System.
Connecting to the PViQ™ Connectivity System via CLI requires a terminal emulation
program such as HyperTerminal or PuTTY. Refer to Logging in with Telnet via PuTTY
to log into the system using a Telnet terminal emulation program.
The following steps are used to perform a firmware update on the PViQ™ Connectivity
System via the Command Line Interface.
1.
At the PSH> prompt in the terminal window type the following command:
a.
start fwupdate
<Server-IP> <filename>
iii. Example: start fwupdate 192.168.0.250 pviq_fw_02_00_01.bin
i. Where the <Server-IP> is the IP address of your TFTP server.
ii. Where <filename> is the name of the file on the TFTP server that
you will be loading on the PViQ™ Connectivity System.
NOTE: The .bin file will be used when upgrading the PViQ™ Connectivity
5. FW Filename
6. Server IP
7. Delay
8. Max Retry
9. Retry Interval
Save
10. Disable Beep
11. Start Update
11a. Status