9
Operating Instructions
Usage
Securing the Stand
Once you are satisfied with where the stand has been
installed, lock the casters and secure the stand prior to
use.
Moving the elite
Panaboard Up or Down
Take hold of the board side frame or board bottom,
and move the elite Panaboard or down. (The figure
provided here shows the elite Panaboard and projector
being used with the stand.)
•
Adjustable range of height
Highest point: 2,120 mm (6 ft. 11
15
/
32
in.)
Point at which the elite Panaboard is stopped by the
first pin end stopper: 1,865 mm (6 ft. 1
7
/
16
in.)
Lowest point: 1,670 mm (5 ft. 5
3
/
4
in.)
(Usually, the elite Panaboard is used at a height
between the highest point and the point at which it is
stopped by the pin end stopper.)
Note
•
The preceding height is the height of the elite
Panaboard unit. (Not including the height of the
projector arm.)
•
The screen of models UB-T880 and UB-T880W serves
as a touch sensor. Avoid touching the screen surface
when raising or lowering the board, because your
finger will be detected and the cursor or electronic pen
position (where the screen was touched previously) will
move to position you touch.
Once you have decided on the height at which the
elite Panaboard is to be used, pull the safety brake
lever down to secure the board in place.
Locking the casters
(Push to lock)
Safety Brake
UE-608030_EN.book 9 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
