Wall Mounting Construction
20
Installation Manual
Wall Types and Installation Procedures
I.
When the Wall is a Principal Structural Component (a concrete wall which is at least 120 mm [4
3
/
4
in.] thick)
Use the M8 bolts to mount the system on the wall. It is also necessary to provide anchors separately. The
figure below shows the end mounting position of the up/down unit and the elite Panaboard vis-à-vis the hole
positions. Check that there is enough space around the mounting position. Carefully read the instructions for
the anchors which will be used, and check the correct hole diameters.
Note
•
The above outline drawing for wall-mounting uses the UB-T880W as an example. The UB-T781 and other
models have a smaller installation surface area than the UB-T880W so they can definitely be mounted if
the space shown in the drawing is available.
Wall-Mounting Construction Procedure
1
Drill the two top holes in the wall.
2
Fasten the anchors to the holes.
3
Insert the M8 bolts into the top left and right anchors and
tighten them up until they only protrude approximately 4 mm
(
5
/
32
in.) from the surface of the wall.
4
With the help of another individual, take the up/down unit out of
its packing box, and hang it on the wall by engaging the
elongated holes at the top of the pipe on the rear surface of the
unit with the two bolts.
5
With the up/down unit hanging on the wall, mark off the
positions of the holes used to secure the bottom part of the
unit, put the up/down unit down, and drill the two bottom holes
in the wall.
6
Fasten the anchors to the bottom holes.
2500 mm
438 mm
530~785 mm
335~785 mm (when the pin end stopper is released)
900 mm
2100 mm
951 mm
A
100 mm
2,100 mm (6 ft. 10
11
/
16
in.)
951 mm (3 ft. 1
7
/
16
in.)
2,500 mm
(8 ft. 2
3
/
8
in.)
438 mm
(1 ft. 5
1
/
4
in.)
900 mm
(2 ft. 11
7
/
16
in.)
100 mm
(3
15
/
16
in.)
530 to 785 mm (1 ft. 8
7
/
8
in. to 2 ft. 6
29
/
32
in.)
335 to 785 mm (1 ft. 1
3
/
16
in. to 2 ft. 6
29
/
32
in.)
(when the pin end stoppers are released)
UB-T880W / UB-T781W
•
UB-T880: Above dimensions less
122 mm (4
13
/
16
in.)
•
UB-T780 / UB-T781 / UB-T780BP:
Above dimensions less 25 mm (
31
/
32
in.)
Projector
A
Panasonic
420 mm (1 ft. 4
17
/
32
in.)
SANYO
567 mm (1 ft. 10
5
/
16
in.)
EPSON
410 mm (1 ft. 4
5
/
32
in.)
Optoma
389 mm (1 ft. 3
5
/
16
in.)
Acer
385 mm (1 ft. 3
5
/
32
in.)
BenQ
425 mm (1 ft. 4
23
/
32
in.)
Bolt
Approx. 4 mm (
5
/
32
in.)
Spring Washer
Flat Washer
(max. diameter of 16 mm [
5
/
8
in.])
UE-608030_EN.book 20 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
