Wall Mounting Construction
26
Installation Manual
3
Align the projector sub-bracket so that the
projector fits in between, and secure both ends
using the toothed washers (
J
) and the screws
(
D
) for securing the projector sub-bracket.
Notice
•
Align the projector sub-bracket so that it supports
the projector, leaving no gaps. Fasten the sub-
bracket securely to the projector on both sides
using the toothed washers (
J
) and screws (
D
)
for securing the projector sub-bracket.
4
Attach the screw (
F
) for securing the pipe
bracket to the pipe bracket (
E
), and secure the
pipe bracket to the projector bracket.
Mounting the Projector Arm
1
Pass the power cable used for the projector
and the video cable through the projector arm.
Notice
•
Ensure that the plugs to connect to the projector
come out at the longer end of the projector arm
(the part where the projector is mounted).
•
If the outlet end of the power cable is too large to
go through the projector arm, the projector arm
cannot be mounted on the up/down unit.
Pass a length of string (twine) through the
projector arm, and then pass the cable with the
string attached to it through the projector arm
after the arm has been mounted on the up/down
unit.
2
Decide on the position of the knob provided on
the rear on the projector arm, and fasten it
tightly.
For SANYO LP-WXL46(S)
Projector Sub-Bracket
Screw for Securing
Projector Sub-
Bracket (
D
)
Toothed Washer for
Securing Projector
Sub-Bracket (
J
)
Pipe Bracket (
E
)
Screw for Securing Pipe Bracket (
F
)
2 to 3 mm
(
3
/
32
to
1
/
8
in.)
Projector End (longer)
Power Outlet End
(shorter)
Top position
Center position
Knob (Bottom position)
Hole for Securing Projector Arm
(Use when moving the stand)
UE-608030_EN.book 26 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
