12
Operating Instructions
Usage
Removing the Foot Reinforcing
Assemblies
While grasping the release lever on the back side of
each foot reinforcing assembly, pull the assembly from
the stand base.
Notice
•
Before moving the stand, be absolutely sure to
remove the foot reinforcing assemblies from the stand
base. If the stand is moved with these assemblies still
attached, it may catch on surrounding objects, cause
somebody to trip over and/or cause injury.
•
In case of securing the foot reinforcing assemblies
using the bolts, please contact your dealer.
Moving the Stand
First get somebody to help you. Then take hold of the
frame on the elite Panaboard sides and protective
cover of the stand, and move the stand together.
Notice
When moving the stand
•
Release the lock lever for each caster.
•
Before moving the stand, disconnect the plug of the
table tap from the wall outlet.
•
Make sure that none of the cables are dragged along
with the stand.
•
Be absolutely sure to have another person ready to
help you move the stand.
•
Take care that none of the equipment placed on the
table plate will fall off.
•
While moving the stand, the stowed projector will
move out of your field of view so while moving the
stand, take care not to allow the projector to bump into
a wall, door or other individuals around you.
After the stand has been moved, follow the steps below to
return it to the condition in which it was before it was moved.
1
Lock the stand’s casters.
2
Turn the casters so that they point inwards.
3
Re-attach the foot reinforcing assemblies.
4
Return the knob currently in the hole for
securing the projector arm to the hole on the
board bracket.
•
If the height of the entrance is less than 2 m
(6 ft. 6
3
/
4
in.), perform step
1
to
4
in the note
(page 11) in reverse.
5
Move the projector in front of the elite
Panaboard.
6
Connect the power cord.
•
Readjust the projector as needed and align it
with the screen.
Foot Reinforcing Assembly
Release Levers
UE-608030_EN.book 12 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
