Assembling the Stands
38
Installation Manual
3
Pull up the pipe part of the stand by hand while
tightening bolts B and C in this order.
Notice
•
Take hold of the pipe part of the stand and, with
the up/down unit pulled up, tighten the bolts.
Right Stand
Left Stand
4
Tighten up bolts A, B and C securely.
5
After attaching the left and right stands, place
the assembled parts upright, and check that
there is no play either at the front or back or at
the left or right.
•
If there is any play in the stand after the
assembled parts have been placed upright,
slightly loosen the three bolts each at the left and
right, adjust so that the play in the stand is
eliminated, and then tighten up the bolts again.
6
Secure the table plate between the left and
right stands.
•
Tip the table as you insert it between both sides
of the stand. Align the table with the position of
the bolt holes, and then tighten the bolts.
Notice
•
Securely tighten the bolts (
8
) for securing the
left and right stands using a force of
5.2 N•m
d
0.5 N•m (53 k
g
f•cm
d
5 k
g
f•cm).
7
Attach the foot reinforcing assemblies.
•
Rotate the casters so that the caster bodies are
turned toward the inside. While taking hold of the
release levers on the foot reinforcing
assemblies, insert the assemblies into the stand,
and align the pins with the holes in the base.
Bolt B
Bolt C
Bolt B
Bolt C
Bolt for Securing Table Plate (
<
)
Spring Washer for Securing Table Plate (
>
)
Flat Washer for
Securing Table
Plate (
?
)
Collar for Securing Table Plate (
=
)
Nut for Securing Table Plate (
@
)
Pin
Foot Reinforcing
Assembly
UE-608030_EN.book 38 ページ ２０１０年１０月２８日 木曜日 午後４時２０分
