104
Controlling Camera Site Accessories
Controls for camera site accessories are located on the
right side of the front panel of the System Controller.
Included are Zoom Control, Focus Control, Iris Control,
Preset and Pan/Tilt Controls. Normally, combination cam-
eras equipped with the specific feature or a WV-RC100 or
WV-RC150 Receiver are required to utilize these functions.
■
Lens Control
Note:
Confirm that the specified lens, with power
zoom/focus functions, is mounted on the camera. Also
confirm that the Lens Selection (DC/VIDEO) on the
camera is set to the DC position.
Function capabilities vary between cameras. Referring
to the operating instructions of each camera is recom-
mended.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Press the
[FOCUS NEAR/FAR]
buttons while observ-
ing the monitor to adjust the lens focus to achieve a
sharply focused picture.
By pressing these buttons at the same time, the lens
focus is set automatically, if the specified camera with
the auto focus feature is used.
3. Press the
[ZOOM TELE/WIDE]
buttons while observing
the monitor to adjust the lens zoom to achieve the
desired picture.
Press the
[TELE]
button to optically bring an object
closer. Pressing the
[WIDE]
button has the reverse
effect.
4. Press the
[IRIS CLOSE/OPEN]
buttons to close/open
the lens iris. Adjust the lens iris by using these buttons
to obtain the proper picture exposure.
By pressing these buttons at the same time, the lens
iris is reset to the factory default setting.
■
Pan/Tilt Control
●
Pan/Tilt Control (Manual Operation)
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the Joystick Controller to move the Pan/Tilt Head
towards the desired direction.
If the joystick is positioned in between UP and R, the
Pan/Tilt Head moves diagonally towards Up and Right.
Eight directions are available: Up / Down / Right / Left /
Up-Right / Up-Left / Down-Right / Down-left.
●
Pan/Tilt Control (Auto Panning)
The following function requires the use of cameras
equipped with this specific feature.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Pressing the
[CAMERA (ENTER)]
button while holding
down the
[SHIFT]
button will activate the Auto Panning
function of the selected camera.
3. To cancel the auto panning function, move the Joystick
Controller.
FOCUS
FAR
NEAR
AUTO FOCUS
ZOOM
TELE
WIDE
IRIS
OPEN
CLOSE
AUTO IRIS
UP
L
R
DOWN
PROGRAM
PRESET
CALL
PRESET
AUX1 OFF
ALM S
CAM ID
T&D
AUX1 ON
VLD S
GEN
WIPER
SYS S
AUX2 OFF
ALM H
AUX2 ON
VDL H
ALL
SHIFT
BLK
EXIT
CLEAR
(ESC)
DEF OFF
DEF ON
CAMERA
(ENTER)
AUTO
PAN
MON STATUS
