Panasonic S-200PE1E8, Technical Data & Service Manual, Page: 194 / 197

8 8
7. Setting Address Switches
•
them to avoid interfering with each other.
•
•
When more than one receiver and remote control are installed in the same room, setting up addresses allows
Refer to the Users Manual for information on how to change the addresses of the remote controls.
Changing the address of a receiver can be done after removing the screw to the receiver’s PCB cover.
Once the change is complete, put the cover back in place; while holding the wiring with the cable clamp, tighten
its screw.
Address Display on
the Remote Control
Position of the
Receiver’s
Address Switch
It doesn’t matter
where the Receiver’s
Address Switch is.
8. Test Operation
(1) Up) and operate the
wireless remote control with its Start/Stop button.
Remove the face plate of the receiver’s PCB and turn the DIP switch to RUN/On (Down
Down) and make
(2)
(3)
(4) During a test run, all display lamps on the display will light up.
During a test run, it is not possible to adjust the temperature.
After completing a test run, be absolutely sure to return the Test Run switch to OFF (Up
sure none of the display lamps are blinking. Also, put the face plate back in place.
NOTE
1.
2.
3.
4.
This is hard on the device, so only use this for the test run.
After turning on the power, the unit will not receive any commands from the remote control for about 1 minute.
This is not an error. (In fact it does receive signals, but they are cancelled.)
Make sure to operate while the indoor unit is stopped.
The address of indoor unit is set to "ALL" at the time of the shipment.
NOTE
1.
2.
3.
When wiring remote controls, be sure to double-check the terminal numbers of the indoor unit connecting them
so there are no mistakes in the wiring. (Damage will occur if high voltage [e.g. supply voltage] is applied.)
If the wiring to the operation panel is bundled together with other wiring, such as the incoming line from the
power source, it can cause a malfunction, avoid doing so.
If something causes the unit’s power source to make noise, it will be necessary to resolve the problem, such as
by installing a noise filter.
8-14
SM830194-04_Single_BigPAC.indb 14 2014/10/31 13:30:52