91
Operations
Web interface operation
“LAN1”, “LAN2”
IP Stack
Sets an IP stack to be used.
IPv4: Communication takes place based on IPv4.
IPv6: Communication takes place based on IPv6.
IPv4+6: Communication takes place based on IPv4 and IPv6.
≥
The initial setting is “Unknown”. (Communication based on IPv4 or IPv6 is not possible)
Speed
Sets a LAN link speed.
Auto: Sets the LAN link speed automatically.
10Mbit/Half: Sets 10-Mbit half-duplex communication.
10Mbit/Full: Sets 10-Mbit full-duplex communication.
100Mbit/Half: Sets 100-Mbit half-duplex communication.
100Mbit/Full: Sets 100-Mbit full-duplex communication.
1Gbit/Full: Sets 1-Gbit full-duplex communication.
≥
The initial setting is “Auto”.
IPv4
Makes settings for IPv4.
≥
The settings can be made when “IP Stack” has been set to “IPv4” or “IPv4+6”.
Enable DHCP
Selects the use or non-use DHCP.
≥
This function is disabled in the initial setting.
Address*
2
Sets an IPv4 address.
≥
Input the address in decimals.
Netmask*
2
Sets a netmask address.
≥
Input the address in decimals.
Gateway*
2
Sets a gateway address.
≥
Input the address in decimals.
IPv6
Makes settings for IPv6.
≥
The settings can be made when “IP Stack” has been set to “IPv6” or “IPv4+6”.
Enable Stateless Auto Config
Selects the use or non-use stateless auto configuration.
≥
This function is disabled in the initial setting.
Enable DHCP
Selects the use or non-use DHCP.
≥
This function is disabled in the initial setting.
Address(Static Assigned)*
2
Sets an IPv6 address.
≥
Input the address in hexadecimals.
Gateway*
2
Sets a gateway address.
≥
Input the address in hexadecimals.
Prefix Length*
2
Sets an IP address prefix length.
≥
Input a decimal number from 0 to 128.
≥
The initial setting is “0”.
*1
Enters the DNS IP address in the format of “IP Stack” when “DNS Automatically” has been disabled.
*2
The settings can be made when “Enable DHCP” has been disabled.
