Panasonic KX-TVS75, Installation Manual

Page: 80 / 318

4.2 CONNECTING THE KX-TVS75/100/200 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308
80
INTEGRATING THE VPS WITH THE PANASONIC KX-TD DIGITAL PBX
CAUTION
Turning the rotary switch to position 5 will default the Voice Processing System, resulting in
a loss of all user programming and voice messages.
9.
Plug in and power up the KX-TVS75/100/200 and wait approximately 90 s while the
system initializes.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2.
Plug in and
turn
the power switch to
ON
on the KX-TD1232. The calls to the VPS can be
processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "CARD TEST" is displayed on the screen.
• "SYSTEM SETUP" is displayed.
Screen output:
• The VPS tests the CPU card, the hard disk drive, and the CO cards
as "SYSTEM SETUP..." is displayed.
• Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
Screen output:
CARD TEST...
SYSTEM SETUP
1... 2... 3...
Active COs: 1 2 3 4
D-PITS Interface Connection is Established
** ON LINE MODE **
Active COs: 1 2 3 4
D-PITS Interface Connection is not Established
** OFF LINE MODE **