Panasonic KX-TVS75, Installation Manual

Page: 235 / 318

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
SYSTEM ADMINISTRATION
235
Other Parameters - Fax Management
The VPS can be programmed to automatically transfer incoming fax calls to a fax extension.
A maximum of 2 fax extensions can be specified as the destination for the Automatic Fax
Transfer. If the main fax extension is not available to receive a fax, the VPS will transfer the
fax transmission to the alternate fax extension.
Release for
Intercom
Paging Up to 12 digits con-
sisting of 0-9, , #
and special codes
(None)
Specifies the intercom paging release code required by the
PBX. Up to 12 alphanumeric characters can be set using
the same letters and dial codes as specified above.
No-Answer
Time for
Intercom
Paging 1-30 sec
(5)
When there is no answer, this parameter specifies the
length of time (in seconds) the VPS must wait before
concluding Intercom Paging.
The VPS will return to the caller if the paged party does
not respond before this timer expires.
Announcement
Repeat Cycle 1-3 times
(1)
Specifies the number of times the intercom page will be
announced.
Example:
"There is a call for (mailbox owner's name)."
Intercom
Paging Retry 1-10 times
(2)
Specifies the number of times paging will be retried when
the paging destination is busy or if there is no answer.
Note
: This setting applies when the subscriber has set only
"Intercom Paging" status to enable in Incomplete Call
Handling Status.
Paging Code
for Group 1-8 Up to 12 digits
consisting of 0-9, ,
# for each group
(none)
Specifies the intercom paging access code required by the
PBX.
Note
: The Intercom Paging Group Number available for
each Subscriber is determined on a COS-by-COS basis.
To select Fax Management, follow the menu path as shown:
System Administration Top Menu - 1 - 5 - 6 - 8
Table 67
Parameter Value Range
(Default)
Description/Function