3.1 Before Installation
3.1.1 Before Installation
Please read the following notes concerning installation and connection before installing the PBX and terminal
equipment.
Be sure to comply with all applicable laws, regulations, and guidelines.
Safety Installation Instructions
WARNING
When installing telephone wiring, basic safety precautions should always be followed to reduce
the risk of fire, electric shock and injury to persons, including the following:
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
Installation Precautions
This set is made for wall mounting (KX-TDE100/KX-TDE200) or floor standing (KX-TDE200 only), and should
be installed in a location where it is accessible for inspections and maintenance.
CAUTION
To prevent malfunction, noise, or discolouration, follow the instructions below:
Do not install the system in the following locations:
•
In direct sunlight and hot, cold, or humid places. (Temperature range: 0 °C to 40 °C)
•
Areas where sulfuric gases may be present, such as near thermal springs.
•
Areas where shocks or vibrations are frequent or strong.
•
High-dust areas, or places the system may come into contact with water or oil.
•
Near devices that generate high frequencies, such as sewing machines or electric welders.
•
Locations where other objects will obstruct the area around the PBX. Be especially careful to leave at
least 20 cm of space above and 10 cm to the sides of the PBX for ventilation.
Notice
Do not install the system in the following locations:
•
On or near computers, telexes, or other office equipment, as well as microwave ovens or air
conditioners. (It is preferable not to install the system in the same room as the above equipment.)
•
Within 1.8 m of radios and televisions. (Both the PBX and PTs should be at least 1.8 m away from such
devices.)
Do not perform the following:
•
Do not block the openings of the PBX.
•
Do not stack up the optional service cards.
Wiring Precautions
Be sure to follow these instructions when wiring the unit:
50
Installation Manual
3.1.1 Before Installation
Summary of Contents for KX-TDE100
