139
Operation Manual
FT1020G3 Rev 2.10.4
26.4
Display Current Consumption in Unit (H5/A4)
26.4.1
Power Supply (Control Unit)
Voltage:
The 24V measured by the CPU on the main board. Corresponds to the output
voltage at the power supply outputs on connector J3.
Earth voltage:
Measured from 0V (connector J4:2) to earth.
Current from power supply:
The total current consumption (including the charging current
at 24V) for the selected control unit (FDCIE) when it is connected to the mains (230 VAC),
i.e. this function is not working by battery backup.
26.4.2
Battery
Voltage:
The battery voltage at connector J4:4-5.
Charging current:
The battery charging current for the selected control unit (FDCIE).
Temperature:
The temperature detected by the battery temperature sensor.
Resistance in battery circuit:
During the battery capacity check the resistance in the
battery circuit is measured. A resistance > 0.5
Ω
will result in a "Low battery capacity" fault.
Checked every 4th hour.
Action
Text in display
Comments
"Menu"
According to chapter
"Access", see page 42.
Scroll to menu H5.
H5 Service
"
↲
"
A1 Calibration of supervised output
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in Control Unit
A5 Display current consumption on COM-loop
A6 Display statistics for communication
A7 Activate address setting mode for DU
A8 Setup wireless detectors
A9 SSD information
Scroll to menu A4.
A4 Display current consumption in control unit
"
↲
"
Select control unit: :
0
0 (press
↵
)
Write control unit
number and press "
↲
".
"
↲
"
Please wait......
No reply from control unit.....
If the control unit is not
exist or not responding.
Power supply
(Control Unit 00)
Voltage: xx.xx V
Earth voltage: xx.xx V
Current from power supply: xxx mA
Battery
Voltage: xx.xx V
Charging current: x mA
Temperature xx°C
Resistance in battery circuit: xxxxx mΩ
Information is
automatically updated
every 5 second.
"
↲
" or "ESC"
A4 Display current consumption in unit
Scroll to another menu
or press "ESC".
Note:
If you get “No reply from control unit…..” the control unit doesn't exist or doesn't
answer
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...
