54
Operation Manual
FT1020G3 Rev 2.10.4
12
Disable/Re-enable Control Outputs
All control outputs programmed as type:
•
Control (general)
•
Ventilation (Smoke control activated)
•
Extinguishing system (Fire protection activated)
•
Interlocking
….. can be collectively disabled via menu H2/B3 for a specified control unit or all control
units. This is indicated by LED Fault / Disablements "General disablements" (L10).
They will remain disabled until re-enabled again via menu H2/B3.
See also chapter “Activate / Reset Outputs (H8/S8)”, page 162. An output can be activated
for an output test even if it is disabled.
See also chapter “Activate / Deactivate Interlocking Output (H9/C2)”, page 165. An
interlocking output can be activated for an output test, even if it is disabled.
26
Terminology of Extinguishing and Ventilation has been changed in the fire brigade panel standard since
AS4428.3:2010 as well as the latest standard AS4428.3:2020. Extinguishing re-named to “Fire Protection
Activated” and Ventilation to “Smoke Control Activated”.
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...
