42
Operation Manual
FT1020G3 Rev 2.10.4
6.1.3
Password for Web-server / Gateway Access only
Normally a password consists of 6 digits. This allows the same user to gain access to the
control unit as well as to the web-server / Gateway, if both are selected.
If a user should have access to the Web-server / Gateway only, it is possible to select a
stronger password. It consists of 6 to 10 characters and digits, letters can also be used.
Note:
The letters are case sensitive
6.2
Access Levels
To use the keypad in FT1020G3 and get access to the menus, it is necessary to log on
with a user name and password for level 2A, 2B or 3A.
Before any SSD is downloaded (e.g. in a brand new control unit), only "0" is shown and no
password is required. After SSD download, the downloaded user names and passwords
will be valid.
6.2.1
How to Log On
1. Open the acrylic door with 003 key. Press the soft key
Menu
.
2. On the keypad, press 0, 1, 2 - - 8 or 9 to select a user. Press
3. Type the password for that user. (Six digits. * * * * * *)
After typing a correct password, the main menu list with the available menus will be
displayed. For "0", Information only, no password is required.
NO ACCESS!
No access will be shown if the entered password was incorrect. Try again.
Note:
After three attempts of entering wrong passwords, the log in function will be blocked
for one hour for each user name respectively.
6.2.2
Navigation / General Procedures
•
Scroll in lists or menus with
.
•
Press
to toggle between different choices.
•
Press soft key
to toggle between different functions.
•
Press
to select / accept.
•
Press the digits on the numeric keypad to select a menu or enter data.
•
A successful disablement is indicated by a beep and a "
√
". It will also be shown in
the Re-enable list.
•
A non-successful disablement is indicated by another beep and a "X".
•
To leave the menu system, press the soft key
ESC
.
•
To logout, close the door.
Quick jump
can be used within each menu, e.g. press "6" for a quick jump to menu H6.
You will be automatically logged out 15 minutes after the last action, and directly when you
close the door. A new login is then required. If you leave the menu system without closing
the door, you have access to the menu system again only by using the soft key "Menu". A
new login is not required.
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...
