Page 5-10
5
. Press the clamp of the feeder into the
clamp block at the back of feeder
table, and then push it down as it is
and fix it.
∗
Be careful not to bump a tape feeder against
another one.
∗
Make sure the feeder is fixed firmly by shaking
its handle lightly.
6
. Close the safety cover, and turn ON
the servo switch.
7
. Press
.
• “Production config menu” is displayed.
NOTICE
Immediately after an operation has started, make sure the carrier tape has been
sent to the chute correctly.
Setting Tape Feeders
Chute
Carrier Tape
Feeder Table
(Correct)
(Incorrect)
Tape is not in
the chute.
Tape is bending.
443C-346P
443C-347P
493C-018E
443C-112E
(NG)
4H4C-019P
4H4C-E-OMA05-A01-01
OFF ( ) ON ( )
SERVO
Summary of Contents for CM301
