Panasonic AJ-YA120AG, Service Manual

Page: 399 / 647

MECH-9
1-14. A/C Head Tilt Adjustment
TP
A/C Head Screw (A), (G)
VFK1586 (Mech. Neutral plate)
VFK1589 (A/C Head Tilt Adjust Tool)
TOOL
VFK1154 (Post Height Adjust Tool)
VFK1178A (0.89mm Hex Driver)
VFK1148A (1.5mm Hex Driver)
SPEC.
There is no gap between A/C Head and Post Height Adjust Tool.
(0
°
± 10
°
)
1. Place the mechanical chassis in the loading completion mode.
2. Mount the A/C Head Tilt Adjust Tool on the Mech. Neutral Plate as shown in figure 1-14-2.
3. Put the Mech. Neutral Plate on the Reel Table.
4. Put the Post Height Adjust Tool along the slope portion of A/C Head Tilt Adjust Tool to A/C Head. Confirm that
the Post Height Adjust Tool is fitted to the surface of the A/C Head.
< Note >:
Loosen the screw (G) and adjust the screw (A). Check the gap between the A/C head and post height
adjustment tool after the tightening the screw (G) at specified torque.
Figure 1-14-1 Figure 1-14-2
VFK1154 VFK1589
VFK1586
Adjust the surface of Mech. Neutral
Plate and A/C Head Height Adjust Tool.
A/C Head Tilt Adjust Tool
Mount it by the 2 screws
enclosed in VFK1589.
Mech. Neutral Plate