Panasonic AJ-YA120AG, Service Manual

Page: 141 / 647

ELE-11
4-6. Auto EQ Adjustment Procedure
A) Preparation
1) Connect the VTR with PC by RS232C cable (Cross cable) as below.
2) Turn the VTR power on.
3) Press the Counter Button on the Front Panel to select the “TC”.
4) Turn the 2
nd
bit of SW1 on the VOUT SYS on.
5) Set the LOCAL/MENU/REMOTE switch on the Front Panel at the “MENU”.
6) Select “022 PB_FORMAT” and then select “AUTO”.
7) Set the LOCAL/MENU/REMOTE switch on the Front Panel at the “REMOTE”.
8) Set the TAPE/EE switch on the Front Panel at the “TAPE”
B) Execution of Software Application.
1) Confirm that the VTR power is on.
2) Select
start
→
Program
→
Panasonic Tool
→
HD1200Rf in the Start menu program in PC.
3) Main screen of the application software appears.
4) Open the program menu and select as follows;
Adjustment: Select “Program
→ → → →
Adjust” .
Measurement: Select “Program
→ → → →
Error Rate” .
5) Select the item needed about adjustment & measurement from. Adjustment/ Measurement item selection
BOX (refer to (a-2)).
6) Select “Program
→ → → →
Start”
7) Input the Serial No. or Manufacture. No. and press “OK” .
8) Follow the indication on the message box. Then adjustment is started automatically.
9) Error result is displayed after executing the adjustment program. Press close button after confirming it.
10) Select
“File
→ → → →
Save” in order to save the Error rate data & EVR data to PC.
11) If it is not needed to save them, skip this process.
(Caution)
This item can not be accessed unless “Data Download” , “Load on File menu” or all adjustment program is
executed.
12) The screen of item (7) appears again. Press “OK” button if serial data information is not required to be
changed.
RS-232C CROSS CABLE
PC
AJ-HD1200A
FLASH MEMORY VERSION
UP TOOL (VFM1304A)
To CONNECTOR PP501 ON
VOUT_SYS BOARD.