PairGain PG-Flex, Manual

Page: 73 / 168

Logging On to Your PG-Flex
65
Logging On to Your PG-Flex
When either an FAU-728 List 2 (Alarm unit) or FPI-729 List 1 Pair Gain Test Controller (PGTC)
interface is installed in your PG-Flex system, you must log on to each system through the Alarm
unit or PGTC interface front panel, where you are prompted for a password. You are not asked for
an additional password when accessing each system. However, if there is no Alarm unit or PGTC
interface installed in your system, you can connect to each system individually through the craft
maintenance port of that system’s line unit. You are then prompted for a password when you log
onto each system
.
Figure 31 shows the logon sequence for accessing a PG-Flex system through an alarm unit or PGTC
interface.
Figure 31. Logon Sequence Through an Alarm Unit or PGTC Interface
Figure 32 shows the logon sequence for accessing a PG-Flex system through a line unit.
Figure 32. Logon Sequence Through a Line Unit
Status
Logon
FPI Main
Connect to
System
Setup
Maintenance
Inventory
Connect to COT
(COT 1 through 4)
Configuration
Main
Status
Logon
Main Menu
Connect to
System
Setup
Maintenance
Inventory
System Time
1st time
logon only