Orbitalum MOBILE WELDER OC PLUS, Operating Instructions Manual

Page: 155 / 204

MOBILE WELDER OC PLUS ENGLISH
ORBITALUM TOOLS GmbH , D-78224 Singen www.orbitalum.com
155
NOTICE Pressing and holding (3 sec.) the "GAS" key on the weld head re-
mote control switches between the "Test Mode" and "Weld Mode"
menus.
2 3 4
5
6
Illustration: "Weld Mode" menu, "START" softkey highlighted in red
NO. CONTROL EL-
EMENT FUNCTION
2 "START"
Softkey Starts the welding process with welding gas and cooling flow, based on the pa-
rameters of the currently loaded welding procedure.
NOTICE! The weld head model programmed in the welding procedure
must match the weld head model connected to the power supply. If weld-
ing procedure parameters are outside the weld head specification, it is not
possible to start the welding process.
3 "Gas" softkey The "Gas" softkey opens a softkey submenu with all functions relevant to
coolant- and welding gas.
See the chapter "Gas" softkey [
}
156]
NOTICE! The "Gas" softkey with softkey submenu is only available if a
cooling unit is connected. If this is not the case, the "Gas" softkey is acti-
vated and the softkey submenu contains only the functions relevant to
welding gas.