Online USV 10000 3/1 XANTO S Series, User Manual

Page: 116 / 192

T R O U B L E S H O O T I N G
116 / 192
XS20000_31_manual_ger_eng_it_V1.1.2.doc R. Kistler
8.1 Warning and error messages
Check the status of the warning and error messages using the fol-
lowing table. Perform suitable measures to rectify this state.
Warning or error
message Possible causes Measure
05 Warning
Cable Fault Loss of one or two phases
Have the cable fault rectified by
a qualified electrician.
06 Warning
Neutral or GND loss Neutral or GND loss
11 Warning
Battery Disconnect The UPS system does not
detect the inner batteries. Check that all batteries are con-
nected properly.
Please contact support.
12 Warning
BATT Deep
Discharge The UPS system is run-
ning in battery mode and
the battery charge state is
low. The UPS system supplies the
connected load with battery cur-
rent only briefly. Prepare the
connected load for the immedi-
ate shutdown.
14 Warning
BATT Overvoltage The voltage of the battery
in the UPS system is too
high. The UPS system switches the
charging device off until the next
charging cycle.
15 Fault
Charging Device
fault The UPS system has de-
tected a charging device
fault. Please contact support.
21 Fault
BUS Over Voltage
Internal fault Please contact support.
22 Fault
BUS Under Voltage
23 Fault
BUS Unbalance
24 Fault
BUS Short
25 Fault
BUS Softstart Fail
31 Fault
Output Short Circuit
Short circuit on output of
the UPS system Disconnect the load from the
UPS system. Switch off the UPS
system. Check the load for
a short circuit. After the short
circuit has been rectified, switch
the UPS system on again.
32 Fault
INV Over Voltage
Internal fault Please contact support.
33 Fault
INV Under Voltage
34 Fault
INV Softstart Fail