Omron SCARA R6Y-XC Series, User Manual, Page: 136 / 203

5-8
CHAPTER 5 Periodic Inspection
5 Replacing the Harmonic Drive
The XC series robots use a harmonic drive as the speed reduction gear for the X,
Y and R axes. Harmonic drives need to be replaced after a specified operation
time. Use the guideline explained below to determine the replacement period
and replace the harmonic drive periodically.
Since the XC series robots use long-life harmonic grease, it is not necessary to
replace the harmonic grease.
5-1 Replacement period
The harmonic drive replacement period is determined by the total number of
turns of the wave generator used in the harmonic drive. It is recommended to
replace the harmonic drive when the total number of turns has reached 8.4×10
8
(at ambient operating temperatures of 0°C to +40°C). This means that the
replacement period will differ depending on the following operating conditions.
If the robot operation duty ratio is high or the robot is operated in environments
at higher temperatures, the harmonic drive should be replaced earlier.
Replacement period = 8.4×10
8
/(n×60×h×D×N×θ) years
where n : Number of axis movements per minute
θ : Average turn per axis movement
N : Speed reduction ratio
h : Operation time per day
D : Operation days per year
For example, when the robot is used under the following conditions, the replace-
ment period for the X-axis harmonic drive of the R6YXC500 can be calculated as
follows.
n : 10
θ : 0.25
N : 80
h : 24 hours per day
D : 240 days per year
Replacement period = 8.4×10
8
/(n×60×h×D×N×θ)
= 8.4×10
8
/(10×60×24×240×80×0.25)
= 12.2 years
Table 5-1 Harmonic drive speed reduction ratio
Robot model
R6YXCH250, R6YXCH350, R6YXCH400
R6YXC500, R6YXC600
R6YXC700, R6YXC800
R6YXC1000
50
80
80
100
50
80
80
80 50
50
50
50
X-axis Y-axis R-axis
Table 5-2 Bolt tightening torque
Bolt size Tightening torque (kgf·cm) Tightening torque (N·m)
M3 button head bolt 14 1.4
M3 20 2.0
M4 46 4.5
M5 92 9.0
M6 156 15.3
M8 380 37
M10 720 71