Omron NT11 - 01-2004, User Manual

Page: 88 / 186

75
Setting the Conditions of Communications with the PLC by Using the Memory Switches
Section 3-7
3-7-3 Selecting the Automatic Restart Function
The “Auto-restart” memory switch is used to set whether or not the communi-
cation is automatically reset after the occurrence of a communication error.
The factory setting has been made at “No”.
Select the Automatic Reset Function of the communication with the PLC by
the menu operation from the System Menu as mentioned below.
To quit after setting the selection made, press the “ENTER” key. To quit with-
out setting the selection made, press any two function keys simultaneously.
• “Yes”: If a communication error has occurred, corresponding error mes-
sage is displayed and the operation stops.
• “No”: If a communication error has occurred, corresponding error mes-
sage will not be displayed and the operation will be automatically reset.
Quit
Transmit Mode
Maintenance Mode
[System Menu] 1.0
PT Setting
I/O Check
Initialize Memory
Memory Switch
Backlight OFF: 10min
Auto-restart : Yes
[Memory SW1] Page:
History Data: Erase
Select “Maintenance
Mode” with the key,
then press “ENTER”.
Select “Memory Switch”
with the key, then press
“ENTER”.
Select “Auto-restart” with
the key.
Pressing the [+/–] key
while “Automatic Reset” is
highlighted will cause the
selection for this item to
alternate between “No”
and “Yes”.