Omron NT11 - 01-2004, User Manual

Page: 82 / 186

69
Registering the Screen Data
Section 3-6
2. Press the “return” key if you want to quit without erasing the program. If you
do want to erase the program, press any two of the function keys simulta-
neously: this will start erasure of the program.
During erasure, the screen shown below is displayed:
3. On completion of erasure, the screen shown below is displayed. At this
point set DIP SW2-6 to the OFF position and reset the NT11.
3-6 Registering the Screen Data
The screen data is created by using the support tool and registered to the
NT11 screen data memory. This section describes the procedure to register
the screen data to the NT11. For the screen data creation and the support tool
operation, refer to the NT-series Support Tool Operation Manual (V061-E1-1).
Transmission – Transmission in File Units
The NT11 uses several screens which are switched on its display. The screen
data of one NT11 unit corresponds to the screens created by using the sup-
port tool. Select a file which contains the screen data to be transmitted when
selecting the screen data to be transmitted to the NT11 so that the required
screen data can be transmitted to the NT11.
It is not possible to send screen data in screen units.
If an error message and the System Menu are displayed immediately after the
NT11 has been started, the screen data memory needs to be initialized.
Erasing...
Erasing is completed
Set DIP-SW2-6 to off
and Power OFF/ON
Screen data file
Screen 1
Screen 2
Screen N
Memory table
Mark data
System memory
Direct connection
information
All screen data are
transmitted by one operation.
NT11
Screen 1
Screen 2
Screen N
Memory table
Mark data
System memory
Direct connection
information
: :