6-10 Starting Operations
6-69
Communications Not Established with Host
Use the following procedure to check communications if the PT and host are not communicat-
ing normally.
Precautions
for Correct Use
The whole system may stop, depending on the method used to turn the power
ON and OFF. Always follow the specified procedure when turning the power ON
or OFF.
Check cables
Check connections host to PT
Check functional object
addresses
Check the addresses and host names set for functional objects. Be
sure that all address settings are within range.
Check the connections between the PT and the host. Refer to
Section 4
Connecting to the Host to Serial Port
and
Section 5 Connecting to Host via
Ethernet or Controller Link
.
Check PT settings
Check the cable models and cable pins.
Refer to
Appendix 5 Preparing Connecting Cables.
Check the communications settings under the System Menu.
Refer to
6-6 Communications Settings.
Check the host settings using the CX-Programmer or other Programming
Device. Refer to
Section 4 Connecting the Host to Serial Port
and
Section 5
Connecting to Host via Ethernet or Controller Link.
Check host settings
Summary of Contents for NS - REV 12
