Omron F3SJ Series, Original Instructions Manual

Page: 48 / 224

28
Chapter
2
Ba
si
c Sys
te
m
F3SJ-A
User’s Manual
System Configuration and Functions
 Wiring for Auto Reset Mode
Wiring the emitter’s circuit as shown below provides auto reset mode.
 Wiring When External Device Monitoring Function Is Not Used
1.Disabling external device monitoring function by the setting tool
Or
2.The external device monitoring function is disabled by connecting auxiliary output 1 and external
device monitoring input as shown below, when auxiliary output 1 settings have not been changed
(output operation mode is "safety output information" and reverse output mode is "enabled").
For mode setting of auxiliary output p.94
S1
* 1
S3
* 1
+24V DC
0V
* 2
K4
S1
S3
K4
: External test switch (connect to 24V if a switch is not required)
: Lockout reset switch (connect to 0V if a switch is not required)
: Load or PLC, etc. (for monitoring)
*1 Use a switch for micro loads (Input specifications: 5V, 1mA)
*2 F3SJ can operate even if K4 is not connected
*3 Green for the single-ended cable F39-JC
A
Power
supply
Interlock selection input (White)
Emitter
(Grey) Communication line (+)
(Pink) Communication line (-)
0V(Blue)
Shield
Reset input(Yellow)
24V(Brown)
Auxiliary output 2(Red)
*3
Test input(Black)
*1
K1 K2 K3
+24V DC
0V
Receiver
(Grey) Communication line (+)
(Pink) Communication line (-)
0V(Blue)
Power
supply
Shield
24V(Brown)
External device monitoring input (Red)
Auxiliary output 1(Yellow)
Safety output 2(White)
K1, K2
K3
: Relay or other device that controls
hazardous parts of the machine
: Load or PLC, etc. (for monitoring)
*1 F3SJ can operate even if K3 is not connected.
If K3 is not required, connect auxiliary output 1
to external device monitoring input only.
*2 Green for the single-ended cable F39-JC
A.
Safety output 1(Black)
*2