SECTIO
N
6
ID
Se
ns
or Unit
O
p
era
tion
SECTION 6
Controlling the ID Sensor Unit
123
RFID System
User's Manual
Copy Command
The following example shows writing the data from RF Tag A for Antenna 1 to RF Tag B for Antenna 2.
1) Use the user program to set the processing address, number of processing bytes, data storage word
address, and other parameters for copying RF Tag data in the Special I/O Unit Area.
2) Use the user program to turn ON the Command Execution Bit (CIO n, bit 00) in the Special I/O Unit
Area.
3) When the ID Sensor Unit detects that the Command Execution Bit has turned ON, it turns ON the ID
Busy Flag (CIO n+7, bit 00).
4) The ID Sensor Unit will read data from RF Tag A and write it to RF Tag B.
5) The ID Sensor Unit writes the data to the RF Tag, places the Results Information (CIO n+8) and
Processing Results Monitor information (word n+9) in the Special I/O Unit Area, turns OFF the ID
Busy Flag (CIO n+7, bit 00), and turns ON the Normal End Flag (CIO n+7, bit 01) for one scan.
The Results Information (CIO n+8) will be held until the Error Reset Bit (CIO n, bit 01) is turned ON or
until the next communications command is received.
(1)(2)
(3)
(5)
(5)
(4)
Antenna 1
Amplifier 1
Special I/O
Unit Area
CIO n to
CIO n+6
CIO n+7
Data storage
area
Read
data
CS/CJ-series CPU Unit
ID Sensor Unit
CIO n+
8
to CIO n+9
RF T
ag
A
RF
T
ag B
Antenna 2
Amplifier 2
Summary of Contents for CJ1W-V680C11
Page 213: ......