Omega Engineering OMB-CHARTSCAN 1400, User Manual

Page: 85 / 273

ChartScan User’s Manual ChartView Software Reference 4-29
Analog Meters
Selecting Analog Meters from ChartView’s Window pull-down menu brings up the Analog Meters
window. This window displays several channels in a dial/gage format. To activate the display, select
the Start button from the toolbar. At least one meter must be assigned to an
active (On) channel. You
can select to view up to 32 meters at a given time.
Analog Meters, Shown with 4 Meters Selected for Viewing
Double-clicking the left mouse button in a meters scale area brings up a channel selection pop-up menu
(not shown). A single-click with the right mouse button in this same area brings up a configuration
pop-up menu (see Bar Graph Meters figure, item H). Both of these pop-up menus are discussed in the
section,
Meters Configuration Menu .
Note that Meter #3 (CH3) in the above figure shows Peak Indicators near the pointer, as well as a
trend indicator in the upper right hand corner of the meter.
The items in this window are as follows:
A- Start C - Reset Peak Hold E - Print G - Number of Meters
B- Stop D - Stay On Top F - Rows x Columns H - Configuration Pop-Up Menu
These items are discussed in more detail, following the description of the Digital Meters.
Configuration Note: …. for Analog Meters
For Analog Meters, configure the meter settings by first clicking the right mouse button anywhere
within the meter display area. A pop-up menu will appear allowing you to reconfigure the meter
in regard to scale, limits, channel selection, adding peak hold indicators, etc. Refer to the section
entitled
Meters Configuration Menu for more detail.