Loading Paper and Documents
- 70 -
Registering Custom Sizes
To load custom size paper, you need to register
the width and length of the paper before printing.
The range of the sizes you can set differs
according to the paper tray.
Note
For tray 1 and tray 2, you can configure the [
Custom
]
setting only when [
Paper Size
] is set to [
Custom
].
The available size range for duplex printing is the same as
that for tray 2.
1
Press the <
SETTING
> key on the
operator panel.
2
Press the to select [
Paper Setup
] and
press .
3
Press the to select the paper tray in
which you loaded paper and then
press .
4
Press the to select [
Custom
] and then
press .
5
Enter the desired value using the ten-key
pad and then press .
Press the or to move to the next box.
6
Press the until the top screen is
displayed.
Paper Output
Your machine outputs to the facedown or faceup
stacker. Paper types that can be outputted to
each stacker are as follows.
When performing duplex printing, paper outputs
to the facedown stacker.
Note
Do not open or close the faceup stacker while printing as it
may result in a paper jam.
Using the Facedown Stacker
Delivers paper with the print side face down.
Note
Check that the faceup stacker on the rear side of the
machine is closed. If the faceup stacker is open, paper is
always outputted to the faceup stacker.
Tray
Available size range
Tray1
Width:
100 to 216 mm (3.9 to 8.5 inches)
Length:
148 to 356 mm (5.8 to 14.0 inches)
Tray2
(Optional)
Width:
148 to 216 mm (5.8 to 8.5 inches)
Length:
210 to 356 mm (8.3 to 14.0 inches)
MP tray
Width:
64 to 216 mm (2.5 to 8.5 inches)
Length:
127 to 1321 mm (5.0 to 52.0 inches)
OK
OK
OK
OK
Output
Stacker
Supported
paper type
Paper output
capacity
Facedown
Standard
Recycled
paper
150 sheets (when
paper weight is less
than 80 g/m
2
)
Faceup
Standard
Recycled
paper
Envelope
Index card
Label
100 sheets (when
paper weight is less
than 80 g/m
2
)
10 sheets (Ultra Heavy
paper and envelopes)
