Replacing Consumable Items
- 164 -
3
Press the top cover open button (1) and
open the top cover.
4
Hold the blue handles (2) of the image
drum unit with both hands and remove
the image drum unit from the machine.
5
Take the new image drum out of its
packaging and remove all packing pieces.
Slide the colored collars to the left to lock
the priming cartridges in position.
Note
Slide the colored collar in a single swift motion.
The priming cartridges (supplied with the new image
drum) can be identified by the orange label on the top
surface. You must use these cartridges to prime your new
image drum before use. Do not re-install your old toner
cartridges at this time.
6
Hold the blue handles (5) of the new
replacement image drum unit with both
hands and place it into the machine so
that the K toner cartridge is positioned in
the front (6).
7
Close the top cover.
Note
The machine will automatically start the priming process.
The priming process takes approximately 4 minutes to
complete. During this time, the Status LED will flash and
the LCD screen will illuminate. Ignore any on-screen
messages.
When the priming process is complete, the engine noise
will stop and the light on the LCD screen will go out. The
Status LED will continue to flash. If your machine has a
Power Save button, this will illuminate.
8
Open the top cover.
9
Remove the priming cartridges. Place
into the recycle bags supplied.
10
Remove the original toner cartridges
from the old image drum (removed in
step 4) and reinstall into your machine.
Reference
Steps 7-9 in "Procedure for Replacement" in
"Replacing Toner Cartridges" (P. 161)
11
Close the top cover.
CAUTION
Possible to get
burned.
The fuser unit is extremely hot. Do not touch it.
Possible to get
burned.
Do not throw a used toner cartridge in the fire.
They may explode, and the toner inside may fly
off and cause getting burned.
1
WARNING
2
CAUTION
5
6
