Oce CS520, User Manual

Page: 329 / 472

11-329
Repeating (Repeat: AUTO/Repeat Mode)
5. Touch
OK
on the Application Selection Screen.
The Basic Screen will be restored.
6. Select the desired magnification and paper size.
• APS and AMS are automatically released, and 1.000 (100%) is selected as
a magnification ratio.
• When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area will
be a portion of the selected paper size equally divided according to the
selected mode.
In this case, magnification ratio will be fixed to 1.000 (100%).
• Copy mode is automatically set to 1 ) 1. If 1 ) 2 is selected, Platen store
mode will function automatically.
7. Enter the desired print quantity from the control panel keypad.
See p. 3-76 for details on setting print quantity.
8. Position original.
For AUTO mode original, open the document feeder, then position the original
FACE DOWN on the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available.
See the illustration on p. 11-327 for details.
When AUTO mode is selected, Non-Image Area Erase functions
automatically.
DO NOT close the document feeder.
9. Press [
START
].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
The AUTO mode may not operate properly if the lighting in the work place is
directly over the platen glass. In this case, consult your service representative
about an appropriate place for installation.