Oce CS2436, User Manual

Page: 577 / 870

Network Setting (CS2436-9)
9. 1. 12.
Network Setting > Network Setting >
Configuring the Communication Mode Manually
This topic gives instructions for configuring the communication mode manually.
1.
On the Tab Selection screen of the Control Panel, press or to select the Settings/
Adj. tab ( ).
Note
･
If the
Tab Selection screen
is not displayed, press the
Menu
button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press or to select
Interface Setup
, and then press the
OK
button.
4.
Press or to select Ethernet Driver , and then press the OK button.
5.
Press or to select Auto Detect , and then press the OK button.
6.
Press or to select Off , and then press the OK button.
The display reverts to the Ethernet Driver menu.
7.
Press or to select Comm.Mode , and then press the OK button.
8.
Press or to select the communication mode, and then press the
OK
button.
The display reverts to the Ethernet Driver menu.
9.
Press or to select Ethernet Type , and then press the OK button.
10.
Press or to select the Ethernet type, and then press the OK button.
The display reverts to the
Ethernet Driver
menu.
11.
Press or to select Spanning Tree , and then press the OK button.
12.
Press or to enable or disable spanning tree support, and then press the
OK
button.
The display reverts to the Ethernet Driver menu.
13.
Press the Menu button.
After the confirmation message is displayed, press the
OK
button.
The new settings will take effect after the printer restarts.
3] file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp06.html (27 of 60) [4-3-2010 11:37:0