Oce CS2436, User Manual

Page: 560 / 870

Network Setting (CS2436-9)
9. 1. 5.
Network Setting > Network Setting >
Configuring the IP Address Using ARP and PING Commands
This topic describes how to configure the IP address using ARP and PING commands.
To use the ARP and PING commands, you will need to know the printer's MAC address. You can
confirm the MAC address on the Control Panel.
1.
Check the printer's MAC address.
You can confirm the MAC address on the Control Panel as follows:
1.
On the Tab Selection screen of the Control Panel, press or to select the
Settings/Adj. tab ( ).
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press or to select Interface Setup , and then press the OK button.
4.
Press or to select Ethernet Driver , and then press the OK button.
5.
Press or to select MAC Address , and then press the OK button.
Note
･
If the
Tab Selection screen
is not displayed, press the
Menu
button.
･ You can investigate the MAC address by printing an interface setting report.
(See "Printing Interface Setting Reports ( 8.2.11 ).")
●
In Windows, open a command prompt, or in Mac OS X, start Terminal.
●
Execute the following command to add entries to the ARP table for managing IP addresses and
corresponding MAC addresses.
arp -s [IP address] [the printer's MAC address you have verified]
Example: arp -s xxx.xxx.xxx.xxx 00-1E-8F-xx-xx-xx
Note
･ In Mac OS X when using Terminal, enter the arp command in the format
arp -s xxx.xxx.xxx.xxx 00:1E:8F:xx:xx:xx.
For details, refer to the help
file for the command line.
3] file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp06.html (10 of 60) [4-3-2010 11:37:0