Oce CS120, Copying Manual

Page: 287 / 381

Adding Patterns (Texture) 4-24
▼
Use the edit pen to designate a point in the center of the area to be scanned;
then press [OK].
Pressing [Cancel] on the screen for specifying the scan area will cause the
whole sample of the texture to be scanned.
Using the designated point as the center, a
5
/
8
" x
5
/
8
" (16 x 16 mm) area
around the designated point will be scanned.
IMPORTANT
.
•
Scan Area Designation is available only if the editor (option) and the IP-ED board
(option) are attached.
●
When you are not designating a specific area to be scanned
▼
Proceed to the next step.
NOTE
.
•
The top-right corner of the texture original measuring
5
/
8
" x
5
/
8
" (16 x 16 mm) in
area will be scanned automatically.
●
When using a pattern that is already scanned
▼
Press [OK] and proceed directly to step 6.
NOTE
.
•
If the sample of the texture is already scanned, <Scanned Data Use> is displayed
above [OK].
Making Copies in the Image Creation Mode
4