Oce CPS900, User Manual

Page: 110 / 138

110 Chapter 6 Maintenance
Loading Paper
When to do
You must load paper in the following cases.
■
When the paper tray is empty or nearly empty.
The paper tray is nearly empty when the icon for a paper tray contains an orange
line.
The paper tray is empty when the edges around the icon and the name of the paper
type are also orange.
■
When the job manager indicates that a job needs a paper type that is not in the
trays (
see ‘The paper manager concept’ on page 17 ).
Before you begin
■
Take the paper from the pack.
■
Remove the top sheet and the bottom sheet.
■
Hold the pack of paper at the two short sides and bend the paper.
Attention: The outside sheets and the edges of the sheets in a pack of paper can
be contaminated with glue from the wrapping. Do not use the contaminated
sheets. If the glue reaches the process, the image drum can get dirty. The key
operator can not clean the image drum. If the image drum is dirty, a service call
is required.
How to load paper in the trays 1, 2 and 3
Attention: The operator only needs the 'Paper manager' when paper of another
type or with another weight is loaded. When the operator refills a paper tray with
the current paper, the 'Paper manager' is not required.
1.
Press the key for the 'Paper manager' to open the 'Paper manager'.
2.
Open the paper compartment door.
3.
Pull out the paper tray that needs the paper.
4.
Put the paper in the paper tray and push the tray back into place. Leave the paper
compartment door opened.
Note: The paper must be loaded face-up in trays 1,2 and 3.
5.
Go back to the 'Paper manager'.
6.
Press the key for the tray that you refilled.
7.
Define the settings for 'Type', 'Weight' and 'Medium', and close the 'Paper manager'.