Oak Telecom VoxBox, User Manual

Page: 131 / 165

Programming Commands
PBX Parameters
Operation Command
Cadence of system input and output tones in
milliseconds *371 + X + YYYY
X = 0; incoming minimum DTMF length
X = 1; busy off
X = 2; busy on
X = 3; Disconnect off
X = 4; Disconnect on
X = *; DTMF off
X = #; DTMF on
YYYY = Cadence in milliseconds in steps of
20 milliseconds
Length of DTMF cadence, sent by the PBX,
e.g. a Disconnect code.
Note: This parameter is needed in order to
calculate the time, which must be truncated
from the end of the message, which is
terminated via the Disconnect code. *372 + X
X = The length of DTMF cadence in ms (0-
9)
Default: 1
Note: Each step represents 100 ms. So by
setting this parameter to 2, the Voice Mail
will cut 200 ms from the end of the
recording.
Busy signal cadence check *375 + XXXX + #
Voice and DTMF sensitivity *376 + X + Y
X = 1; Voice sensitivity level
X = 2; DTMF sensitivity level
Y = Level (0-9), 9 = Most sensitive
Default: 5
Note: To activate the new selection, a new
call must be initiated
Automatic Gain Control (AGC) *377 + X
X = 0; AGC disabled
X = 1; AGC enabled (Default)
Note: To activate the new selection, a new
call must be initiated
DTMF amplitude *379 + X
X = volume level (3-9), 9 = Loudest
Default: 5
Voice Mail and Auto Attendant System Installation and Programming Manual 10-7