OPERATION
22
SpeedScrub Rider 331140 (9- 2013)
8. Remove and clean the vacuum fan filter.
Clean the filter with a damp cloth or low
pressure water hose if dirty. Allow the vacuum
fan filter to dry completely before reinstalling it
in the machine.
9. Close the recovery tank cover.
10. Remove the solution tank drain hose. While
holding the hose up, remove the plug, then
slowly lower the drain hose to the floor drain
or sink.
11. Tilt the recovery tank back to access the
solution tank. Make sure the recovery tank is
empty before tilting.
12. Flush the solution tank and rinse the float
sensor located inside the back part of the
solution tank. Rinse the screen filter on the
bottom of the tank.
13. Carefully push the recovery tank forward to
close the solution tank.
14. Unhook the seat latch and lower the operator
seat.
15. Clean the front of the solution tank through
the front access port located under the front
solution tank cover. Wipe the bottom of the
cover and the tank seal before replacing the
cover.
