OPERATION
11
SpeedScrub Rider 331140 (9- 2013)
FILLING THE SOLUTION TANK
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
The machine is equipped with a fill port at the rear
of the machine.
WARNING: Flammable materials can
cause an explosion or fire. Do not use
flammable materials in tank(s).
FOR CONVENTIONAL SCRUBBING:
Open the
solution tank fill port and partially fill it with water
(not to exceed 60
C / 140
F). Pour the required
amount of detergent into the solution tank
according to mixing instructions on the bottle.
Then continue filling the solution tank with warm
water until the water level is just below the fill port.
FOR SAFETY: When using machine, follow
mixing and handling instructions on chemical
containers.
FOR FaST or
ec- H2O
SCRUBBING:
Use cool
clean water only (less than 21
C / 70
F). Do not
add any conventional floor cleaning detergents,
system failure may result.
NOTE: When filling the solution tank with a
bucket, make sure that the bucket is clean. Do not
use the same bucket for filling and draining the
machine.
ATTENTION: For Conventional Scrubbing,
only use recommended cleaning detergents.
Machine damage due to improper detergent
usage will void the manufacturer’s warranty.
MACHINE OPERATION
PRE- OPERATION CHECKLIST
-
Check the machine for fluid leaks.
-
Check the battery fluid and charge level.
-
Check the tank cover seals for damage and
wear.
-
Clean the vacuum fan inlet filter.
-
Check the condition of the scrubbing brushes.
Remove any string, banding, plastic wrap, or
other debris wrapped around them.
-
Cylindrical brushes: Check that the debris tray
is empty and clean.
-
Check the squeegees for damage, wear and
for deflection adjustment.
-
Check the vacuum hose for debris or
blockage.
-
Drain and clean the recovery tank.
-
Check the brakes and steering for proper
operation.
-
Check the service records to determine
maintenance requirements.
-
Check the horn, headlights, taillights, safety
lights, and backup alarm (if equipped).
-
FaST Scrubbing:
Check the FaST- PAK
(option) concentrate agent level. Replace
carton as needed. See the INSTALLING THE
FaST- PAK AGENT section of the manual.
-
For FaST or
ec- H2O
Scrubbing:
Ensure
that all conventional cleaning agents are
drained and rinsed from the solution tank.
-
For FaST or
ec- H2O
Scrubbing:
Ensure
that the solution tank is filled with
clear cool
water only.
BEFORE OPERATING
Pick up oversized debris before scrubbing. Pick
up pieces of wire, string, twine, etc., that could
become wrapped around the scrub brush.
Plan the scrubbing in advance. Try to arrange
long runs with minimum stopping and starting. Do
an entire floor or section at one time.
Pre- sweep the area to prevent streaking.
