OPERATION
9
SpeedScrub Rider 331140 (03- 2015)
MACHINE SETUP
ATTACHING SQUEEGEE ASSEMBLY
1. Stop machine on a level surface.
2. Turn the machine
ON/OFF key switch
off.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Place the rear squeegee under the squeegee
mount bracket and fasten with the two knobs.
4. Connect the vacuum hose to the squeegee
assembly. Loop the hose as shown using the
hose clip provided.
The squeegee deflection is set at the factory.
If the squeegee blade needs adjustments, see
ADJUSTING REAR SQUEEGEE BLADE
DEFLECTION section of this manual.
INSTALLING BRUSHES/PADS
To install the brushes or pad, see
REPLACING
DISK SCRUB BRUSHES OR PAD DRIVER
or
REPLACING CYLINDRICAL SCRUB BRUSHES
section of this manual.
ec-H2O NanoClean WATER CONDITIONING
CARTRIDGE (ec-H2O NanoClean model)
(
ec-H2O models labeled ec-H2O NanoClean)
The ec-H2O system is equipped with a water
conditioning cartridge. The cartridge is designed
to protect the machine’s plumbing system from
potential scaling. The cartridge is located under
the seat.
The cartridge is required to be replaced when it
reaches its maximum water usage or expiration
time of when the cartridge was activated, which
ever comes first.
Depending on machine usage a new cartridge can
last anywhere from 12 to 24 months.
All cartridges are labeled with a manufacture date.
The shelf-life of an un-installed cartridge is one
year from manufacture date. For new cartridge
replacement, the ecH2O module timer must be
reset. See ec-H2O NanoClean WATER
CONDITIONING CARTRIDGE REPLACEMENT.
ATTENTION:
During first time use and after
replacing the water conditioning cartridge, the
ec-H2O system will automatically override the
selected solution flow rate for up to 75 minutes.
The ec-H2O system indicator light will blink
green/red when it’s time to replace cartridge.
