OPERATION
13
SpeedScrub Rider 331140 (03- 2015)
ECONOMY SETTING
The machine will operate for a longer time if the
Brush Pressure
and
Solution Flow
settings are in
the
Economy
setting. The bottom lights of the
Brush Pressure
and
Solution Flow
settings are on
when the machine is in the Economy setting.
ec-H2O NanoClean SOLUTION FLOW SETTING
(ec-H2O models labeled ec-H2O NanoClean)
To adjust the solution flow rate when ec-H2O
scrubbing, press the solution flow button located
on the ec-H2O module. One LED= low, two
LED’s=medium, and three LED’s= high. The
ec-H2O module is located under the seat.
NOTE
:
For ec-H2O models manufactured before
ec-H2O NanoClean models, contact an
Authorized Service Center if solution flow rate
adjustment is required.
SCRUBBING
FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
1. Turn the
On/Off key switch
on.
2. Turn on lights (if equipped).
3. Select the preferred scrubbing settings (See
SETTING SCRUB MODES).
4. Press the
One Step Scrub button
. The light
on the button is illuminated. All the preset
scrubbing functions will turn on.
NOTE
:
Open the control panel cover to adjust the
Brush Pressure and Solution Flow Setting while
scrubbing if necessary.
NOTE
:
DO NOT turn the ec- H2O/FaST system
on during conventional scrubbing. Conventional
cleaning detergents/restorers may cause failure to
the FaST/ec- H2O solution system. Drain, rinse
and refill solution tank with cool clean water
before operating the FaST/ec- H2O system.
