OPERATION
10
SpeedScrub Rider 331140 (03- 2015)
INSTALLING THE FaST- PAK (FaST Model)
1. Stop machine on a level surface.
2. Turn off the machine
ON/OFF key switch
.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Open the FaST- PAK compartment door and
slide the empty FaST- PAK approximately half
way out from the FaST- PAK compartment
door.
4. Squeeze the button on the FaST supply hose
connector, then pull the empty FaST- PAK out
from the compartment.
5. Remove the perforated knock outs from the
new FaST- PAK carton. Do Not remove the
bag from the carton. Pull out the hose
connector located on the bottom of the bag
and remove the hose cap from the connector.
NOTE: The FaST- PAK Floor Cleaning
Concentrate is specially designed for use with the
FaST system scrubbing application. NEVER use
a substitute. Other cleaning solutions may cause
FaST system failure.
6. Insert the new FaST- PAK approximately half
way into the FaST- PAK compartment.
7. Connect the FaST- PAK hose connector to
the FaST supply hose connector, slide the
FaST- PAK the rest of the way into the
FaST- PAK compartment, and close the
FaST- PAK compartment door.
8. When replacing an empty FaST- PAK carton,
you must scrub with the FaST system for a
few minutes before the detergent will reach its
maximum foaming.
