MAINTENANCE
33
SpeedScrub Rider 331140 (10- 2015)
SCRUB BRUSHES
The machine can be equipped with either
disk
or
cylindrical
scrub brushes, or cleaning pads. Check
scrub brushes daily for wire or string tangled
around the brush or brush drive hub. Also check
for brushes damage and wear.
DISK BRUSHES AND PADS
Replace the pads when they no longer clean
effectively. Replaces the brushes when they no
longer clean effectively or when the bristles are
worn to the yellow indicator.
Cleaning pads must be placed on pad drives
before they are ready to use. The cleaning pad is
held in place by a pad holder.
Cleaning pads need to be cleaned immediately
after use with soap and water. Do not wash the
pads with a pressure washer. Hang pads, or lie
pads flat to dry.
NOTE: Always replace brushes and pads in sets.
Otherwise one brush or pad will be more
aggressive than the other.
REPLACING DISK BRUSHES OR PAD DRIVER
1. Stop machine on a level surface. Make sure
the scrub head is in the raised position.
2. Turn the machine
ON/OFF key switch
off.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Pull the pin from the side squeegee retainer
pivot.
4. Open the side squeegee retainer pivot toward
the front of the machine, then pull the side
squeegee toward the rear of the machine to
access the scrub brushes or pads.
