OPERATION
12
SpeedScrub Rider 331140 (03- 2015)
SETTING SCRUB MODES
Before scrubbing, select the type of scrubbing will
be used, FaST (option),
ec- H2O
(option) or
conventional scrubbing. Then set the preferred
brush pressure and solution flow settings.
SETTING FaST BUTTON
The FaST button enables the FaST system to
come on when the One Step Scrub button is on.
The light next to the button will come on when it is
in this mode.
NOTE: The solution flow cannot be adjusted when
the machine is in the FaST mode.
SETTING
ec- H2O
BUTTON
The
ec- H2O
button enables the
ec- H2O
system
to come on when the One Step Scrub button is
on. The light next to the button will come on when
it is in this mode.
NOTE: The ec- H2O system indicator light will not
turn on until the machine starts scrubbing.
ec- H2O System
Indicator Light
ATTENTION:
ec-H2O NanoClean Models-
During first time use and after replacing the water
conditioning cartridge, the ec-H2O system will
automatically override the selected solution flow
rate for up to 75 minutes.
SETTING BRUSH PRESSURE
Under normal conditions, the brush pressure
should be set to the minimum setting (the bottom
light). Under heavy grime conditions, the brush
pressure should be set to the maximum setting
(the top light). Travel speed and floor conditions
will affect scrubbing performance.
With the
One Step Scrub button
on, press either
the
Brush Pressure increase button (+)
or the
Brush Pressure decrease button (- )
to set the
scrubbing pressure for the surface being cleaned.
The new pressure setting will default to this
setting when the machine is powered on or off.
SETTING SOLUTION FLOW
NOTE: The solution flow cannot be adjusted when
the machine is set for FaST scrubbing or for
ec-H2O scrubbing on ec-H2O models manufactured
before ec-H2O NanoClean models.
Under normal soilage conditions the solution flow
level should be set to the lowest setting (the
bottom light). Under heavy grime conditions, the
solution flow level should be set to the higher
settings (middle or top lights). Travel speed and
floor conditions will affect scrubbing performance.
With the
One Step Scrub button
on, press either
Solution increase button (+)
or
Solution decrease
button (- )
to set the solution flow level for the
surface being cleaned. The new solution flow
setting will default to this setting when the
machine is powered on or off.
