MAINTENANCE
31
SpeedScrub Rider 331140 (9- 06)
CHARGING THE BATTERIES WITH THE
ON- BOARD CHARGER
NOTE: If your machine is equipped with the
on- board battery charger, make sure that the
charger is properly set for your battery type before
charging (See CHECKING ON- BOARD
BATTERY CHARGER SETTINGS).
1. Drive the machine to a flat, dry surface.
NOTE: Make sure the area is well ventilated.
2. Turn the machine
ON/OFF key switch
off.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Tilt the operator seat forward and hook the
seat latch into place to hold up the seat
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep
sparks and open flame away. Keep
covers open when charging.
4. Connect the charger’s AC power supply cord
into a properly grounded wall outlet.
5. The charger will display a sequence of codes
once the cord is connected.
Three- the following code:
A = Charging current
U = Battery Voltage
h = Charging time
C = Charging ampere- hours [Ah]
E = Energy used [Kwh]
6. Press the arrow button to review the codes.
Once the charging cycle begins, the indicator
lights will progress from red, yellow to green.
When the green indicator light comes on, the
charging cycle is done. Unplug the charger cord.
If the charger detects a problem, the charger will
display an error code. See
ON- BOARD
BATTERY CHARGER ERROR CODES
.
ON- BOARD BATTERY CHARGER ERROR CODES
DISPLAY CODE
FAULT
SOLUTION
bat
Loose or damaged battery cable
Check battery cable connections.
Battery exceeded maximum volt-
age level.
No action necessary.
E01
Exceeded maximum battery volt-
age allowed.
No action necessary.
E02
Safety thermostat exceeded
maximum internal temperature.
Check if the charger vents are obstructed.
E03
Exceeded maximum time for
charging phase leaving the batter-
ies undercharged due to a sulfated
or faulty battery.
Repeat the charging cycle and if the error
code E03 reappears check battery or
replace it.
SCt
Safety timer exceeded maximum
charging time. Interrupts charging
cycle.
Replace battery.
Srt
Possible internal short circuit.
Contact Service Center.
