MAINTENANCE
42
SpeedScrub Rider 331140 (9- 2013)
SQUEEGEE BLADES
The side squeegees control water spray and
channel water into the path of the rear squeegee.
The side squeegee blades are not adjustable.
The rear squeegee assembly channels water into
the vacuum fan suction. The front blade channels
the water and the rear blade wipes the floor.
Check the squeegee blades daily for damage and
wear. Rotate or replace the squeegee blades if
the leading edge is torn or worn half-way through
the thickness of the blade. Replace the side
squeegee deflectors if they become worn.
The rear squeegee can be adjusted for leveling
and deflection. The deflection and leveling of the
squeegee blades should be checked daily, or
when scrubbing a different type of floor.
The rear squeegee assembly can be removed
from the squeegee pivot to prevent damage
during transport of the machine.
REPLACING (OR ROTATING) THE REAR
SQUEEGEE BLADES
1. Stop machine on a level surface. Make sure
the scrub head is in the raised position.
2. Turn the machine
ON/OFF key switch
off.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Remove the squeegee suction hose from the
rear squeegee assembly. Then loosen both
rear squeegee assembly mounting knobs.
4. Pull the rear squeegee assembly from the
machine.
5. Loosen the rear squeegee retaining band
tension latch and remove the retaining band.
6. Remove rear squeegee blade from the rear
squeegee assembly.
7. Loosen the two outer knobs on the rear
squeegee assembly. Remove the front
squeegee blade from the squeegee assembly.
8. Install the new front squeegee blade or rotate
the existing blade to the new edge. Be sure
the holes in the front squeegee blade are
hooked onto the tabs on the front blade
clamp.
