Nikon NWL860 Series, Manual

Page: 8 / 96

5
Chaper 1 General Description
1
5. Hardware and Setting
Some ROMs used with the NWL are not designed for IFC function. If the ROM name does not include
“-IFC”, it cannot be used for communications.
Additionally, some NWLs are not designed for IFC function. To add IFC functionality to these NWLs, you
must upgrade the ROM and modify related settings.
<NWL860INX>
The circuit board and the internal cable required for communications are built in.
Use ROMs for NWL3A-IFC version 2.30 or later.
● Setting
①
Change the ROM if it is not designed for IFC function.
②
Turn on DipSW (1 of SW1) on the control circuit board.
③ Turn on power.
④ Proceed through the steps below, following the instructions given in the operation panel. (The steps
may vary slightly with different ROM versions.)
A prompt for conversion appears in the display screen.
Select “Cnvrt”. The conversion starts.
Upon completion, the “Welcome NWL860” screen (the screen shown at startup) is displayed.
<NWL860TMB-SP>
The circuit board and internal cable required for communications are built in.
Use ROMs for NWL3R-IFC version 2.30 or later.
* NWL860TMBs other than type SP lack the required circuit board and internal cable. Those models
cannot communicate with external devices, even with upgraded ROMs.
● Setting
①
Change the ROM if it is not designed for IFC function.
②
Turn on DipSW (1 of SW1) on the control circuit board.
③
Turn on power.
④ Proceed through the steps below, following the instructions given in the operation panel. (The steps
may vary slightly with different ROM versions.)
A prompt for conversion appears in the display screen.
Select “Cnvrt”. The conversion starts.
Upon completion, the “Welcome NWL860” screen (the screen shown at startup) is displayed.