Nexsan BEAST Series, User Manual, Page: 38 / 267

5. Set access privileges for individual hosts by checking or unchecking the box in the Use Default column:
If Use Default is checked, the host or host group will use the Group Default setting (if the host is part
of a group) or the Default Access setting (if the host is not part of a group). This is the default setting.
If Use Default is unchecked, this setting overrides the Group Default and Default Access settings.
Select Deny , Read , or R/W to set the access privileges for the specific host.
Note If at any time you wish to return the Map Logical Volumes page to its initial state, click Reset .
6. When you have finished assigning host access privileges, click Apply Changes . A message is
displayed, indicating that the settings have been saved.
For more information about volumes, see Configure Volumes on page 138. For more information about host
access, see Configure Host Access on page 162.
When the Quick Start Configuration Check List is complete
When you have finished configuring the settings listed on the Quick Start Configuration Check List , do the
following:
►
When the Quick Start Configuration Check List is complete:
1. Scroll to the bottom of the list.
2. Uncheck the Show the configuration checklist on home page check box.
3. Click Close Checklist .
You are taken to the Home page (see Home page on page 57).
Chapter 1: Basic Setup — Set up the system
Nexsan High-Density Storage
User Guide
www.nexsan.com
38